View Single Post
      09-19-2019, 07:27 AM   #36
j1980mac
Captain
United_States
263
Rep
964
Posts

Drives: 2018 X3 M40i
Join Date: Apr 2018
Location: Austin TX

iTrader: (0)

Quote:
Originally Posted by CanAutM3 View Post
Quote:
Originally Posted by low135 View Post
They're underrated numbers from factory. Compare them with most other manufacturers and you'll see that. Ford RS makes almost 70hp less than it's advertised bhp. That's a huge number.
No, they are not "underrated". Engine ratings are highly regulated, car manufacturers cannot publish any numbers they want.

As I said, one needs to get familiar with the SAE and DIN engine power rating standards and understand the operation fundamentals of modern turbocharged engines to understand what is going on with the numbers.

In short, engines behave differently when in steady state (constant RPM) than when in transient state (while accelerating). Modern turbocharged engines usually tend to make more power in transient than in steady state in the mid to high RPM band while making less in the lower RPM.

Traditionally, power rating standards required the engine to be tested in steady state, which allows for much better control of the test environment for more accurate and repeatable results. The engine is held for a few minutes at a given RPM at WOT until all the parameters stabilize before the measurements are taken. The engine is then accelerated to the next RPM point and the process is repeated across the RPM range.

With the avenue of modern turbocharged engines, the SAE has modified the standards to allow manufacturers to take advantage of the engine characteristics and now allows them to test in transient if they so desire. The caveat is that they leave it up to the manufacturers to chose which of the two method they want to obtain their ratings, so it makes it difficult to compare numbers between manufacturers.

BMW and most European manufacturers choose to stick with the traditional steady state method for their ratings likely because it is more accurate and repeatable. This is why the numbers seem "underrated" when compared to numbers obtained on a chassis dyno that operates in transient state.
That's interesting.
Appreciate 0