[draytology]

I have an E92 335i and the yellow brake light is illuminated.

I recently purchased the car so I thought I just needed brakes. I changed all 4 rotors, pads and both sensors. I realized that my previous sensors were actually still ok.
I also checked the brake fluid. I used Protool to reset front and rear brake counters.
After this did not work I suspected a problem with the brake sensor harness, so I used a multimeter to verify a signal was present. Both sensor plugs showed a voltage of +-12.5v.

So, I have a signal at the plugs, I have brand new sensors installed, not to mention the old sensors were still ok, and the brake light remains on. What else could it be because I am at a loss.

Thanks

[mapleleaf1773]

Would the abs module need bled?

[relative4]

Pull... the... codes....