[PandaNL]

Hi All,

I installed a CIC retrofit in my E92 335i, this part went fine including VO coding etc, however I had no sound. Did a bit of research and found this thread where someone with the same issue updated the AMP60 module (https://www.m3post.com/forums/showthread.php?t=1191466)

So I do not have a icom cable yet, but the flash would not take longer then 10 minutes, so I used a k-dcan cable. The battery is brand new and is a bosch 95a. but to be sure i started the engine.

During the flash I get a gear can be engaged without brake warning, after the flash I got sound. But this issue remains everytime I start the car.

Tried to clear fault memory via Inpa-d, but the error comes back, and when driving I get a transmission error and cannot use paddle flippers to shift.

I haven't tried to clear memory + disonnect battery for a few minutes. Will try this after work.

Is the above related to the coding or is it just a coincidence and is the transmission bad?
Don't know if it matters, but came to mind that I have pin 7 & 8 bridged for the older E series, could this cause issues?

[PandaNL]

So after clearing the error about 3 times every issue disappeared and all wen back to normal.